Boom Lift Spec Sheet
JLG Toucan VM3242E Spec Sheet
Quick-reference specifications for the JLG Toucan VM3242E. Includes extracted performance, dimensions, capacities, and other details found in the source PDF.
Up and Over Platform Height: 22 ft (6.70 m)
Machine Weight: 7720 lbs (3500 kg)
BHESPECS note: Specs can vary by configuration, serial range, and market. Always confirm against the machine data plate and the source PDF.
Performance
| SECTION | 5 – JIB AND PLATFORM |
|---|---|
| Travel speed (Forward and Reverse) High drive – | 2.3 m.p.h. (3.8 km/h) [28-32 sec / 100 ft] |
| Gradeability | 20%. |
| Turning Radius Inside – | 0 ft (0 m) |
| Jib Speed Lift up | 10-16 seconds |
| Turntable Swing Speed (Left and Right) From rest to rest | 50-65 seconds |
| Up and Over Platform Height | 22 ft (6.70 m) |
| Max. Platform Height | 26.6 ft (8.10 m) |
| Swing Bearing Race | 1 grease fitting |
| Jib Assembly w/Cylinder | 174 |
| Jib Cylinder | 66 |
Dimensions
| Machine Height (Stowed) | 6.5 ft (1.99m) |
|---|---|
| Machine Length (Stowed) | 10.5 ft (3.20m) |
| Machine Width | 42 in (1.06 m) |
Weights & Electrical
| SECTION | 7 – BATTERY / CHARGER |
|---|---|
| Battery – Battery Charger Battery | 3 battery packs of 8 volts, 560 ampHour (5 hour |
| rate) (each pack is composed of | 4 two volts |
| cells). Charger | Input, 110-220 VAC, 50-60 Hz – Output, 24 VDC |
| Assembly Motor – 24 VDC, | 3 kW. |
| Assembly Motor – 24 VDC, | 0.8 kW |
| Machine Weight | 7720 lbs (3500 kg) |
| Horizontal Reach Up and Over | 9.5 ft (2.90 m) |
| NOTE | Lubrication intervals are based on machine opera- |
| Open Gear Lube Mobil MOBILTAC | 81 |
| stamped on the front beam of the frame. Table | 1-3. Major Component Weight |
| Steering Knuckle (each) | 68 |
| Drive Motor (each) | 70 |
| Counterweight | 2800 |
Powertrain & Systems
| Drive w / mast raised – | 0.4 m.p.h. (0.7 km/h) [35-38 sec / 50 |
|---|
Hydraulics & Capacities
| SECTION | 6 – HYDRAULICS |
|---|---|
| Hydraulic Oil Tank – Main | 5.8 gallons (22 liters) |
| Hydraulic System Approximately | 8 gallons (30 liters) |
| Hydraulic Oil Tank – Steering Unit 0.25 gallon ( | 1 liter) |
| Hydraulic System – Steering Approximately | 0.4 gallon (1.5 liter) |
| Pump – | 0.49 cu.in/rev (8 cm³/t) Pump Output, 3.1 gpm (12 l/mn) at 2000 psi (138 bar) |
| Pump – | 0.03 cu.in/rev (0.5 cm³/t) 1.3 |
| Ground Bearing pressure | 200 PSI (14 kg/cm²) |
Lubricants & Fluids
| NOTE | Used oils and filter cartridges must be disposed of |
|---|---|
| Wheel Hub Bearing | 2 grease fittings |
Flipbook / PDF Viewer
If the embed doesn’t show, use a WordPress Shortcode block for the pdf-embedder shortcode.
